Extreme Networks ExtremeWare XOS Guide - Configuring IP Multicast Routing; Configuration Examples

Configuring IP Multicast Routing
ExtremeWare XOS 11.3 Concepts Guide
583
To display the IGMP snooping filters, use the following command:
show igmp snooping {vlan} <name> filter
Configuring IP Multicast Routing
To configure IP multicast routing:
1 Configure the system for IP unicast routing.
2 Enable multicast routing on the interface using the following command:
enable ipmcforwarding {vlan <name>}
3 Enable PIM on all IP multicast routing interfaces using the following command:
configure pim add vlan [<vlan_name> | all] {dense | sparse} {passive}
4 Enable PIM on the router using the following command:
enable pim
Configuration Examples
Figure 78 and Figure 79 are used in Chapter 25 to describe the Open Shortest Path First (OSPF)
configuration on a switch. See Chapter 25 for more information about configuring OSPF.