Extreme Networks ExtremeWare XOS Guide User Manual

Verifying QoS Configuration and Performance
ExtremeWare XOS 11.3 Concepts Guide
307
Link Counter: Up 0 time(s)
VLAN cfg:
Name: Default, Internal Tag = 1, MAC-limit = No-limit
STP cfg:
s0(disable), Tag=(none), Mode=802.1D, State=FORWARDING
Protocol:
Name: Default Protocol: ANY Match all protocols.
Trunking: Load sharing is not enabled.
EDP: Enabled
DLCS: Unsupported
lbDetect: Unsupported
Learning: Enabled
Flooding: Enabled
Jumbo: Disabled
BG QoS monitor: Unsupported
QoS Profile: None configured
Queue: Qp1 MinBw=0% MaxBw=100% Pri=1
Qp2 MinBw=0% MaxBw=100% Pri=2
Qp3 MinBw=0% MaxBw=100% Pri=3
Qp4 MinBw=0% MaxBw=100% Pri=4
Qp5 MinBw=0% MaxBw=100% Pri=5
Qp6 MinBw=0% MaxBw=100% Pri=6
Qp7 MinBw=0% MaxBw=100% Pri=7
Qp8 MinBw=0% MaxBw=100% Pri=8
Ingress Rate Shaping : support IQP1-2
IQP1 MinBw= 0% MaxBw=100% Pri=1
IQP2 MinBw= 0% MaxBw=100% Pri=2
Ingress IPTOS: Disabled
Egress IPTOS: Replacement disabled
Egress 802.1p: Replacement disabled
Smart Redundancy: Unsupported
VLANs monitored for stats: Unsupported Unsupported
Software redundant port: Unsupported
jitter-tolerance: Unsupported
NOTE
To ensure that you display the QoS information, you must use the detail variable.
Verifying QoS Configuration and Performance
You can display a variety of QoS measures using the CLI.
Monitoring Performance—BlackDiamond 10K Switch Only
NOTE
This command is not supported on the BlackDiamond 8800 family of switches or on the Summit X450 switch.

Extreme Networks ExtremeWare XOS Guide Specifications

General

Brand	Extreme Networks
Model	ExtremeWare XOS Guide
Category	Software
Language	English