Route Redistribution
ExtremeWare XOS 11.3 Concepts Guide
561
NOTE
The number of routers in an OSPFv3 point-to-point link is determined per VLAN, not per link.
NOTE
All routers in the VLAN must have the same OSPFv3 link type. If there is a mismatch, OSPFv3 attempts to operate,
but it may not be reliable.
Route Redistribution
More than one routing protocol can be enabled simultaneously on the switch. Route redistribution
allows the switch to exchange routes, including static routes, between the routing protocols. Figure 74 is
an example of route redistribution between an OSPFv3 AS and a RIPng AS.
Broadcast Any Routers must elect a designated router (DR) and a backup designated
router (BDR) during synchronization. Ethernet is an example of a
broadcast link.
Passive A passive link does not send or receive OSPFv3 packets.
Table 70: OSPFv3 link types (Continued)
Link Type Number of Routers Description
To Next Page
Loading...
Need help?
General
