Extreme Standby Router Protocol
ExtremeWare XOS 11.3 Concepts Guide
478
â—Ź ELRP packets received.
For more information about the output associated with the
show elrp command, see the ExtremeWare
XOS Command Reference Guide.
ESRP Examples
This section provides examples of ESRP configurations.
Single Domain Using Layer 2 and Layer 3 Redundancy
The example shown in Figure 53 uses a number of Extreme Networks devices as edge switches that
perform Layer 2 switching for ESRP domain esrp1 and VLAN Sales. The edge switches are dual-homed
to the BlackDiamond 10K switches. The BlackDiamond 10K switches perform Layer 2 switching
between the edge switches and Layer 3 routing to the outside world. Each edge switch is dual-homed
using active ports to two BlackDiamond 10K switches. ESRP is enabled on each BlackDiamond 10K
switch for the ESRP domain esrp1 that interconnects to the edge switches. Each BlackDiamond 10K
switch has the VLAN Sales configured using the identical IP address. The BlackDiamond 10K switches
then connect to the routed enterprise normally, using the desired routing protocol (for example, RIP or
OSPF).
To Next Page
Loading...
Need help?
General
