Extreme Networks ExtremeWare XOS Guide - Page 205

Event Management System/Logging
ExtremeWare XOS 11.3 Concepts Guide
205
To configure a parameter match filter item, use the following command:
configure log filter <name> [add | delete] {exclude} events [<event-condition> | [all
| <event-component>] {severity <severity> {only}}] [match | strict-match] <type>
<value>
Each event in ExtremeWare XOS is defined with a message format and zero or more parameter types.
The
show log events all command can be used to display event definitions (the event text and
parameter types). Only those parameter types that are applicable given the events and severity specified
are exposed on the CLI. The syntax for the parameter types (represented by
<type> in the command
syntax above) is:
[address-family [ipv4-multicast | ipv4-unicast | ipv6-multicast | ipv6-unicast]
| bgp-neighbor <ip address>
| bgp-routerid <ip address>
| eaps <eaps domain name>
| {destination | source} [ipaddress <ip address> | L4-port <L4-port>| mac-address
<mac-address>]
| esrp <esrp domain name>
| {egress | ingress} [slot <slot number> | ports <portlist>]
| ipaddress <ip address>
| L4-port <L4-port>
| mac-address <mac_address>
| netmask <netmask>
| number <number>
| port <portlist>
| process <process name>
| slot <slotid>
| string <match expression>
| vlan <vlan name>
| vlan tag <vlan tag>]
Beginning with ExtremeWare XOS 11.2, you can specify the ipaddress type as IPv4 or IPv6, depending
on the IP version. The following examples show how to configure IPv4 addresses and IPv6 addresses:
● IPv4 address
To configure an IP address, with a mask of 32 assumed, use the following command:
configure log filter myFilter add events all match ipaddress 12.0.0.1
To configure a range of IP addresses with a mask of 8, use the following command:
configure log filter myFilter add events all match ipaddress 12.0.0.0/8
● IPv6 address
To configure an IPv6 address, with a mask of 128 assumed, use the following command:
configure log filter myFilter add events all match ipaddress 3ffe::1
To configure a range of IPv6 addresses with a mask of 16, use the following command:
configure log filter myFilter add events all match ipaddress 3ffe::/16
● IPv6 scoped address
IPv6 scoped addresses consist of an IPv6 address and a VLAN. The following examples identify a
link local IPv6 address.
To configure a scoped IPv6 address, with a mask of 128 assumed, use the following command:
configure log filter myFilter add events all match ipaddress 3ffe::1%Default