Virtual Router Configuration Example
ExtremeWare XOS 11.3 Concepts Guide
247
● The VLAN helix-accounting is created
● Ports that belong to the virtual router helix are added to the VLAN helix-accounting
The CLI prompt is shown in this example to show how the virtual router configuration domain is
displayed. At the end of the example, the virtual router is ready to be configured for OSPF, using
ExtremeWare XOS commands.
* BD10K.1 # create virtual-router helix
* BD10K.2 # configure vlan default delete ports 3:*
* BD10K.3 # configure vr vr-default delete ports 3:*
* BD10K.4 # configure vr helix add ports 3:*
* BD10K.5 # configure vr helix add protocol ospf
* BD10K.6 # virtual-router helix
* (vr helix) BD10K.7 # create vlan helix-accounting
* (vr helix) BD10K.8 # configure helix-accounting add ports 3:1
* (vr helix) BD10K.9 #
To Next Page
Loading...