To Next Page

To Previous Page

Using the Simple Network Management Protocol

ExtremeWare XOS 11.3 Concepts Guide

you associate it with a parameter name, so you must create different target parameter names if you use

different filters for different target addresses.

To create a target parameter name and to set the message processing and security settings associated

with it, use the following command:

configure snmpv3 add target-params [[hex <hex_param_name>] | <param_name>] user [[hex

<hex_user_name>] | <user_name>] mp-model [snmpv1 | snmpv2c | snmpv3] sec-model [snmpv1

| snmpv2c | usm] {sec-level [noauth | authnopriv | priv]} {volatile}

To display the options associated with a target parameters name or all target parameters names, use the

following command:

show snmpv3 target-params {[[hex <hex_target_params>] | <target_params>]}

To delete one or all the target parameters, use the following command:

configure snmpv3 delete target-params [{[[hex <hex_param_name>] | <param_name>]} |

all]

Filter Profiles and Filters

A filter profile is a collection of filters that specifies which notifications should be sent to a target

address. A filter is defined by a MIB subtree and mask and by whether that subtree and mask is

included or excluded from notification.

When you create a filter profile, you are associating only a filter profile name with a target parameter

name. The filters that make up the profile are created and associated with the profile using a different

command. To create a filter profile, use the following command:

configure snmpv3 add filter-profile [[hex <hex_profile_name>] | <profile_name>] param

[[hex <hex_param_name>]] | <param_name>] {volatile}

After the profile name has been created, you associate filters with it using the following command:

configure snmpv3 add filter [[hex <hex_profile_name>] | <profile_name>] subtree

<object_identifier> {/<subtree_mask>} type [included | excluded] {volatile}

The MIB subtree and mask are discussed in “SNMPv3 MIB Access Control” on page 89, as filters are

closely related to MIB views. You can add filters together, including and excluding different subtrees of

the MIB until your filter meets your needs.

To display the association between parameter names and filter profiles, use the following command:

show snmpv3 filter-profile {[[hex <hex_profile_name>] | <profile_name>]} {param [[hex

<hex_param_name>] | <param_name>]}

To display the filters that belong a filter profile, use the following command:

show snmpv3 filter {[[hex <hex_profile_name>] | <profile_name>] {{subtree}

<object_identifier>}

To delete a filter or all filters from a filter profile, use the following command:

configure snmpv3 delete filter [all | [[hex <hex_profile_name>] | <profile_name>]

{subtree <object_identifier>}]]

Extreme Networks ExtremeWare XOS Guide User Manual

Questions and Answers: