Extreme Networks ExtremeWare XOS Guide User Manual

Managing the Switch
ExtremeWare XOS 11.3 Concepts Guide
94
Automatic Daylight Savings Time changes can be enabled or disabled. The default setting is enabled.
To disable automatic Daylight Savings Time, use the command:
configure timezone {name <std_timezone_ID>} <GMT_offset> noautodst
3 Enable the SNTP client using the following command:
enable sntp-client
After SNTP has been enabled, the switch sends out a periodic query to the NTP servers defined in
step 4 (if configured) or listens to broadcast NTP updates from the network. The network time
information is automatically saved into the onboard real-time clock.
4 If you would like this switch to use a directed query to the NTP server, configure the switch to use
the NTP server(s). If the switch listens to NTP broadcasts, skip this step. To configure the switch to
use a directed query, use the following command:
configure sntp-client [primary | secondary] <host-name-or-ip> {vr <vr_name>}
NTP queries are first sent to the primary server. If the primary server does not respond within 1
second, or if it is not synchronized, the switch queries the secondary server (if one is configured). If
the switch cannot obtain the time, it restarts the query process. Otherwise, the switch waits for the
sntp-client update interval before querying again.
5 Optionally, the interval for which the SNTP client updates the real-time clock of the switch can be
changed using the following command:
configure sntp-client update-interval <update-interval>
The default
sntp-client update-interval value is 64 seconds.
6 You can verify the configuration using the following commands:
■ show sntp-client
This command provides configuration and statistics associated with SNTP and its connectivity to
the NTP server.
■ show switch {detail}
This command indicates the GMT offset, the Daylight Savings Time configuration and status, and
the current local time.
absolute_day Specifies a specific day of a specific year on which to begin or end DST. Format is:
<month> <day> <year> where:
• <month> is specified as 1-12
• <day> is specified as 1-31
• <year> is specified as 1970 - 2035
The year must be the same for the begin and end dates.
time_of_day_hour Specifies the time of day to begin or end Daylight Savings Time. May be specified as an
hour (0-23). Default is 2.
time_of_day_minut
es
Specify the minute to begin or end Daylight Savings Time. May be specified as a minute
(0-59).
noautodst Disables automatic Daylight Savings Time.
Table 14: Time zone configuration command options (Continued)

Extreme Networks ExtremeWare XOS Guide Specifications

General

Brand	Extreme Networks
Model	ExtremeWare XOS Guide
Category	Software
Language	English