RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e Card Printer User Guide (L001172 Rev. 1.1)
6-77
Using the Overlay / Print Area
Use these Overlay / Print Area options to control both the print and overlay together or
control each individually. (Note: Determine whether to use the Frontside option (via the
Front radio button) or the Backside option (via the Back radio button).)
Step Procedure
1 Select For Print and Overlay for the defined area to apply to both the printing and
overlay process.
OR
Select For Overlay Only for the defined area to apply only to the overlay process.
(Note: In this mode, printing will still be allowed over the entire card and only the
overlay will be affected.)
OR
Select For Print Only (No Overlay) for the defined area to apply only to the print
process. (Important: In this mode, the overlay is completely disabled so it will not
be applied.)
Caution: An overlay or an overlaminate must protect dye-sublimation
printing or it will quickly begin to wear or fade.
To Next Page
Loading...
