RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e Card Printer User Guide (L001172 Rev. 1.1)
4-30
Resolving a Headlift Motor or Sensor Error
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1 Review the following information.
• Symptom: The Printhead continuously cycles or does not cycle at all
• Printer Error State: Headlift Sensor is not detecting movement from the
Headlift Cam
• Driver Monitor Error Display: General Error
To Next Page
Loading...
