Fargo DTC400e - Resolving a Ribbon RFID Error (Ribbon RFID Antenna Is Corrupted)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e Card Printer User Guide (L001172 Rev. 1.1)
4-9
Resolving a Ribbon RFID Error (Ribbon RFID Antenna is Corrupted)
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1 Review the following information.
• Symptom: Printer RFID Sensor does not detect a recognizable signal from
the Ribbon.
• Printer Error State: The Ribbon tag information is corrupted or incorrect.
• Driver Monitor Error Display: Ribbon RFID Error