RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e Card Printer User Guide (L001172 Rev. 1.1)
3-1
Section 3: Setup and Installation
Procedures
The following guide will walk you through the installation of the DTC400e Card Printer Driver.
• Time Requirement (software): This software installation process will require
approximately 2 to 5 minutes (depending on the speed of your PC).
• Time Requirement (Printer): The time required to set up a standard DTC400e Printer
would be approximately 5 to 10 minutes.
The System Requirements are as follows:
• x86 PC or compatible, Windows 2000, Windows XP, Windows 2003, 500MHz computer
with 256MB of RAM or higher, 500MB free hard disk space or higher
• Printer Setup and Installation
Printer Setup and Installation
Choosing A Good Location
Follow these guidelines:
• Place the unit in a location with adequate air circulation to prevent internal heat build up.
• Use the Printer's dimensions as a guideline for the minimum clearances to the unit.
(Note: Allow for adequate clearance in front of the unit to accommodate the unit with its
Covers open.)
• Do not install unit near heat sources such as radiators or air ducts or in a place subject
to direct sunlight, excessive dust, mechanical vibration or shock.
About Moisture Condensation
If the unit is brought directly from a cold to a warm location or is placed in a very damp room,
moisture may condense inside the unit. Should this occur, print quality may not be optimum.
Leave the unit turned OFF in a warm, dry room for several hours before using. This will allow
the moisture to evaporate.
To Next Page
Loading...
