RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e Card Printer User Guide (L001172 Rev. 1.1)
5-43
Changing the Root Password
The Passwords page allows the User to change the passwords needed to log in as a User.
Changes to all settings require a login. (Note: However, these changes are only protected
by password after the password has been set. Users can only be added or removed using
Telnet commands.)
Step Procedure
1 Select the Administration link.
2 Select the Passwords link to get to the Password web page.
3 Enter the current password in the Root Password Old textbox or leave it
blank if no password has been previously set.
4 Enter the new password in the Root Password New textbox or leave it
blank if you want to remove the old password.
5 Re-enter the new password in the Root Password Confirm textbox or
leave it blank if you want to remove the old password.
Continued on the next page
To Next Page
Loading...
Need help?
General
