Fargo DTC400e - Diagnosing Image Problems

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e Card Printer User Guide (L001172 Rev. 1.1)
4-40
Diagnosing Image Problems
Resolving the Pixel Failure problems
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1 Review the following information.
• Symptom: A thin line or scratch travels the entire length of the card (See
sample image below).
• Printer Error State: None
• Driver Monitor Error Display: None
2 Check the card stock for scratches. Replace the cards (as needed).
3 Examine the Printhead for visible damage.
4 Clean the Printhead. See the procedure Cleaning the Printhead
5 Replace the Printhead if the problem persists.