Fargo DTC400e - Restoring the Factory Settings for Ethernet; Restoring the Default Settings

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e Card Printer User Guide (L001172 Rev. 1.1)
5-55
Restoring the Factory Settings for Ethernet
There may be times when you are unable to use the current configuration of the Ethernet
interface. (Note: This could be because you have lost the password for your Printer or you
just cannot get it to work properly.)
• Restore default settings: The Printer has switches on the back which will restore the
factory default settings to the Printer.
• Dipswitch indicators: For the DTC400e, ON means a Dipswitch is down and OFF
means a Dipswitch is up.
• Lost Password or Printer Problems: There may be times when you are unable to use
the current configuration of the Ethernet interface. (Note: This could be because you
have lost the password for your Printer or you just cannot get it to work properly.)
Enter this mode by following this procedure.
Step Procedure
1 Remove power from the Printer.
2 a. Place the switch furthest from the LEDs in the ON position (Dipswitch 1
ON).
b. Place the switch closest to the LEDs in the OFF position (Dipswitch 2
OFF).
3 Reconnect power to the Printer.
4 After 30 seconds, remove power, restore both switches to their normal
position (which is OFF) and then restore power.
Restoring the Default Settings
The DTC400e has switches on the back which will restore the factory default settings to the
Printer.
• Dipswitch indicators: For the DTC400e, ON means a Dipswitch is down and OFF
means a Dipswitch is up.
To enter this mode on the DTC400e, follow the next procedure.