RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e Card Printer User Guide (L001172 Rev. 1.1)
6-126
Using the Flipper Smart Angle Offset Option
Use this option to change the Flipper angle relative to the default smart card loading position.
This is done in order to adjust travel to and from the Flipper and the Smart Card Docking
Module.
Step Procedure
1 Enter a negative value to decrease the amount of Flipper angular movement
from the home position to the smart card loading position.
Or
Enter a positive value to increase the amount of Flipper angular movement
from the home position to the smart card loading position.
(Maximum Adjustment Range: The maximum adjustment range is ± 5. 1 is
approximately 1 degree.)
Using the Print Temperature Offset
Step Procedure
1 Adjust the printing temperature for the rewriteable cards as needed.
• Increase the Current Setting to cause more heat to be used in the
printing process.
OR
• Decrease the Current Setting to cause less heat to be used in the
printing process.
(Note: Print Temp Offset provides user ability to control Printhead heat level
when the Print (Write) Operation is performed on rewriteable cards. Higher
heat level needs to be applied for darker printing on rewriteable cards. A
lower setting will produce a lighter image on rewriteable cards accordingly)
To Next Page
Loading...
Need help?
General
