RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e Card Printer User Guide (L001172 Rev. 1.1)
5-53
Upgrading the Main Firmware with the Fargo
Workbench Printer Utility
The Main Printer Firmware upgrades are done with the same procedure as the USB-
connected Printer. The PC doing the upgrade must have a Driver installed for the Fargo
Printer to be upgraded. (Note: Alternatively, a DTC400e User can upgrade the DTC400e
Main Printer Firmware by using the DTC400e Upgrade web page.)
Step Procedure
1 Run the Fargo Workbench Printer Utility by selecting from the start menu the
following:
Start -> Programs -> Fargo -> Fargo Workbench Printer Utility
2 Select the Fargo Printer to upgrade from the Actions Menu, as shown below.
To Next Page
Loading...
