Power
Input
Fuse
Supply (Line)
Fuse Action
Fuse Rating
Wavetek-Datron Manufacturer
Voltage
UUCSA
Part No.
& Type No.
115VAC
T
lA
2400-05-0029
BUSSMAN
MDL
1
Timedelay
T
BUSSMAN
MDL
112
230VAC
Timedelay
500 mA
2400-05-0010
The Power Cord and Power Supply Disconnection
The power supply disconnect device is the ON 1OFF switch on the rear
panel
of
the instrument. The
ON
1OFF switch
should be readily accessible whilst the instrument is in operation.
If
this operating condition cannot
be
satisfied,
it
is
essential that either the power cord plug or a separate power disconnecting device be readily reached and accessible
to
the operator.
To avoid electric shock and frre hazard, ensure that the powercord is not damaged and is adequately rated against power
supply network fusing.
If
the powerplug is to be the accessible disconnecting device, the cord must not be longer than
3 metres.
Connection
to
Instrument Terminais
Ensure that the instrument is correctly Earthed (Grounded) via its power cord before and whilst any otherconnection
ismade.
Installation Category 1
Measurement and/or guard terminaIs are designed for connection at Installation (Over voltage) Category
1.
To
avoid
electric shock
or
frre hazard the instrument terminals must not
be
connected directly
to
the mains power supply
or
any
other source
of
voltage
or
CUITent
that might temporarily exceed the
peak
ratings
of
the instrument
WARNING
&
To
avoid
in
jury
or
1088
of
life,
do
not
connect
or
disconnect
signalleads
while
they
are
connected,
or
suspected
of
being,
connected
to
a
hazardous
voltage
or
eurrent
source
(internai
or
external
to
the
instrument).
Maintenance and Repair
Local
or
national safety regulations andrules for the prevention
of
accidents and hazard must be observed
in
aIl work
performed.
The
unit
must
be
disconnected from all signal sources and then the power supply before
the
removal
of
covers.
Any
ad
justm
en
t, parts replacement, maintenance
or
repair should be carried out only by authorised Wavetek-
Datron technical personnel.
WARNING
&
For
continued
protectionagainst
injury
and
fire
hazard
il
is essential
that
only
manufacturer
supplied
parts
be
used
to
replace
parts
relevant
to safety.
Safety
tests
must
be
performed
after
the
replacement
of
parts
relevant
to
safety.
Ventilation and Oust
The instrument relies on forced air cooling via a fan and ventilation slots. Adequate ventilation can usually
be
achieved
by positioning on a level surface and by leaving a 75
mm
(3" gap) around the instrument. Care should he taken
to
avoid
restricting the airflow to
or
from the fan at the rearlsides
of
the instrument as damage
may
result from overheating.
Cleaning
Ensure the instrument signal and
tOOn
power leads are disconnected prior to cleaning. Use only a damp, lint
me
cloth
to
clean
fada
and case parts.
Observe
any
additional
safety
instructions
or
warnings
given
in
this
manual.
xi
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
