5-28 Remote Operation
CALibration:ENABLe?
Sending the query returns the state
of
the
rear
panel
Cal
Enable switch. A 0
indicates the switch is in the "NORM" position. When a 1 is returned, the switch
is set to "CAL."
CALibration:STATe
<ON
1 OFF>
Sending this program message enables correction
of
the output amplitude
and
offset voltage levels using the calibration data stored in nonvolatile memory.
If
the
calibration corrections are disabled then default corrections are used.
5.6.3 DISPlay
[ :WINDowJ
:TEXT
[:DATAJ
<string>
:CLEar
:UPDate
DISPlay:TEXT[:DATAJ
<string>
This command allows you to send a message to the display to provide information
or
an operator prompt.
The
message
contained
in
the
<string>
characters
is
displayed on the screen. The message may be multi-line; you select line breaks
with the backslash (\) character. The message can have a maximum
of
4 tines
of
20 characters each. Excess lines and characters can be viewed using the knob
or
cursor keys. Characters can be any standard ASCII value from
"32"
(space) to
"125"
0). The message remains
on
the display until c1eared with the
DISPlay:1EXT:CLEar message.
If
a new
1EXT
command is sent while a previous
one is still being displayed, the original
1EXT
box is automatically removed before
the new one is displayed.
DISPlay:TEXT:CLEar
This command removes the message dialog box created by the DISPlay:
TEXT
<string> commando
DISPlay:UPDate
This command causes the front panel display to he redrawn, using the last current
set
of
commands executed to determine which information should be displayed.
Under
normal
remote
operation, the
display
is
not
updated
when
the
remote
interface is "busy", and it may lag behind the current instrument setup.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
