Fluke Wavetek-Datron 395 - Reset

PMARker
BCOMplete
LCOMplete
TSOurce
SMARker
PENLift
5.6.7 RESet
Selects Position Marker as the source.
Selects Burst Done as the source.
Selects Loop Done as the source.
Selects Trigger as the source.
Selects Sweep Marker as the source.
Selects Pen Lift as the source.
RESet
Sending this program message resets aIl parameters to their default state. This
program message bas no effect on the TRACe subsystem. FoIlowing is a list of
Model 395 defaults:
5-32 Remote Operation
Amplitude
AM Mode
Frequency
AM State
Filter
FilterMode
Function Mode
Function Shape
Marker Position
Mode
Offset
Output
Sequence Trigger
Sequence Advance
Sweep Direction
SweepMode
Sweep Spacing
Sweep Start
Sweep Stop
SweepTime
Sync Source
Sync Output
Trigger
Count
Trigger Rate, InternaI
Trigger Source
1
Vp
Off
1 kHz
Off
20 MHz Elliptic
Auto
Fixed
Sinusoid
o
Continuous
O.OVdc
Off
Edge
Auto
Up
Continuous Reset
Linear
1 kHz
10kHz
1 second
SyncMarker
Off
1
5ms
Internai
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com