Fluke Wavetek-Datron 395 - Model395 as a Function Generator; Example 1. Setting up the Function Generator

Channel 1 Trigger
son
Tennination
~)lflMain
Out
8--. __ -1- son
Tennination
Model395
Figure 5-12. Model395 to Scope Interconnection
Connect the Model 395 to an instrument controller, such as a computer, thatsends SCPI
commands via RS-232 orIEEE-488 (option 001 - IEEE-488 InterfacelDirect Waveform
Transfer). Setup the interface as described
inparagraph 5.3 (RS-232) or 5A (IEEE-488).
·5.5.1 Model 395 As a Function Generator
As a function generator, the Model 395 generates sine, square, triangle, positive ramp,
negative ramp, positive haversine, negative haversine, sin(x)/x, and dc waveforms with
programmable amplitudes to 10 Vp-p.
Example 1. Setting Up the Function Generator
This example sets up the Mode1395 to produce a continuous, 4.58 MHz, 5A Vp-p square
wave with a -1.2
Vdc offset; see figure 5-13. This example is the SCPI equivalent of
example 1 in paragraph 3.6.
Note
The following commands are shown on separate lines for clarity.
When sending actual
command strings, the commands can be one
continuous string with the programmessage terminator, <pmt>, at the
end.
5-14 Remote Operation
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com