Fluke Wavetek-Datron 395 - THE Model 395 as a TRIGGER GENERATOR; Example 9 Setting up the Triggered Generator

Step 6 Enabling Sweep
You can select the Sweep mode from either the Sweep Setup screen or the Mode screen.
From the Sweep Setup screen, press F5
"on" to switch to the sweep mode. From the
Mode screen, press
F2 "sweep" ta enable the sweep mode. Selecting either one also
enables the Sweep Out connectar which produces a ramp proportionaI to the sweep time.
Step 7 Setting Up Trigger Source
Set up the trigger source and trigger rate via the Trigger screen, enabled by pressing the
TRIGINkey.
<> source : internai
<> slope : positive
<> level : +0.00 V
• period : 1.0000 ms
Select the internaI trigger source by pressing FI "source" untÏl "internai" appears. Set
the trigger period to 15 seconds by pressing
F4 to select "period" then enter:
ENTER
(,--_1 -..JI] (,--_5-J] 0
The Model 395 is now generating a swept sine wave.
3.11 THE MODEl 395 AS A TRIGGER GENERATOR
Example 9 Setting up the Triggered Generator
In this example you will setup the Model 395 to generate a triggered Sin (x)/x waveform
for a count
of five waveforms. This example uses the Model 395' s MAN TRIG key to
trigger the waveforms. Paragraph 5.5.6, example 9 contains
the remote sePI programming
equivaIent
of this example. First setup the Model 395 as described in example 1, steps
1, and 2.
Introduction To The Model 395 3-27
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com