-20°C
to +70°C
Less than 95% at
11°C to +30°C.
Less 15,000 feet (4570 meters).
Less than 2g.
Less than 40g.
2.4 PREPARATION FOR STORAGE, SHIPMENT OR OPERATION
Packaging
[fpossible, always use the original shipping container. However, when using packing
rnaterials other than the original, use the following guidelines:
Wrap the Model 395 in plastic packing material.
Use a double-walled cardboard shipping container.
Protect all sides with
shock
absorbing material (minimum
of
2 inch thick
material) to prevent movement
of
the Model 395 within the container.
Seal the shipping container with approved sealing tape.
Mark "FRAGILE" on all sides, top, and bottom
of
the shipping container.
Storage
The
Model
395 should
be
stored
in
a clean, dry environment.
[n
high
humidity
environments, protect the Model 395 from temperature variations that could cause
internal condensation. The following environmental conditions apply to both shipping
and storage;
Temperature
Relative Humidity (sea level)
Altitude
Vibration
Shock
Operation
The Model 395 should be operated on a flat surface or in an equipmentrack within ils
envoronmental specifications. AlI air vents should
he clear
of
obstructions.
Signal connections should not
be
made to external hazardous voltages.
WARNING
THIS INSTRUMENT CAN DELIVER A LETHAL ELECTRIC SHOCK. NEVER
TOUCH
ANY
LEAD
OR
TERMINAL
UNLESS
YOU
ARE
FIRST
ABSOLUTELY CERTAIN THAT NO DANGEROUS VOLTAGE IS PRESENT.
SEE THE SAFETY ISSUES SECTION AT -rHE FRONT OF THIS MANUAL.
2.5 LINE VOLTAGES AND FUSES
The Model395 accepts a primary inputvoltage
of
either 90 to 132 Vac
or
198 to
252
Vac, 50/60 Hz. Wavetek-Datron ships the
Model395
set for the line voltage
and
wîth
the proper fuse for the destination country. Figure
2-1
illustrates the location
of
the
line
voltage switch and fuse holder.
2-2 Initial Preparation
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
