Fluke Wavetek-Datron 395 - Page 178

First, connect the Mode1395, the scope, and the "controller" as described in "Initial
Setup"
of paragraph 5.5.
Second ,set up the pulse train by sending these commands:
*RST;
[:SOURce] : FUNCtion:PTRAin:COUNt 3;
FUNCtion:PTRAin:BASEline -4;
FUNCtion:PTRAin:PERiod Se-li
FUNCtion:PTRAin:TRANsition[:STATe] 1;
FUNCtion:PTRAin:LEVel 4 ,0;
FUNCtion:PTRAin:TRANsition:LEADing 32e-3 ,0;
FUNCtion:PTRAin:TRANsition:TRAiling 64e-3 ,Oi
FUNCtion:PTF~in:WTnTh 1?~-2 ,0;
FUNCtion:PTRAin:DELay 40e-2 ,0;
FUNCtion:PTRAin:LEVel 2 ,1;
FUNCtion:PTRAin:TRANsition:LEADing Se-3 ,li
FUNCtion:PTRAin:TRANsition:TRAiling Se-3 ,1;
FUNCtion:PTRAin:WIDTh 6e-2 ,1;
FUNCtion:PTRAin:DELay 3e-l , 1;
FUNCtion:PTRAin:LEVel -2 ,2;
FUNCtion:PTRAin:TRANsition:LEADing Se-3 ,2;
FUNCtion:PTRAin:TRANsition:TRAiling 32e-3 ,2i
FUNCtion:PTRAin:WIDTh Se-2 ,2;
FUNCtion:PTRAin:DELay 42e-2 ,2; <pmt>
Finally, send these commands to output the pulse:
[:SOURce] :FUNCtion[:SHAPE] PTRAin;
:INITiate:CONTinuousi
: OUTPut [:STATe] l;:OUTPut:SYNC[:STATe] 1; <pmt>
:
•
•
.....
II
\
\ \
!
\
1
\
r ~
,
Figure 5-18. Pulse Train Example
Remote Operation 5-23
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com