Fluke Wavetek-Datron 395 - Page 252

Information/Error Messages
E.1 INTRODUCTION
Appendix E
This appendix lists error messages that will be generated during operation.
E.2 SCPI MESSAGES
Below is a list of SCPI error messages thatmight occur during operation. Each is listed
inside quotes. For a detailed description
of what each error codemeans, refer to the 1993
SCPI Command Reference manual, Chapter 21, "SYSTem:ERRor?"
0,
-100,
-101,
-102,
-103,
-104,
-105,
-108,
-109,
-110,
-111,
-112
-113
-114
-120
-121
-123
-124
-128
-130
-131
-134
-138
-140
-141
-144
-148
-150
-151
-158
-160
-161
-168
-170
"No error"
"Command error"
"Invalid character"
"Syntax error"
"Invalid separator"
"Data type error"
"GET not allowed"
"Parameter
not allowed"
"Missing Parameter"
"Command header error"
"Header separator error"
"Program mnemonic too long"
"U ndefined header"
"Header suffix out
of range"
"Numeric data error"
"Invalid character in number"
"Exponenttoo large"
"Too many digits"
"Numeric data not allowed"
"Suffix error"
"Invalid suffix"
"Suffix too long"
"SuffIx not allowed"
"Character data error"
"Invalid character data"
"Character data too long"
"Character data not allowed"
"String
data error"
"Invalid string data"
"String data not allowed"
"Block
data error"
"Invalid hlock data"
"Block data
not allowed"
"Expression error"
Information/Errar Messages E-1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com