Foundry Configuration Guide for the FESX, FSX, and FWSX
19 - 26 © Foundry Networks, Inc. December 2005
Syntax: show ip pim rp-set
This display shows the following information.
Displaying Multicast Neighbor Information
To display information about the Layer 3 Switch’s PIM neighbors, enter the following command at any CLI level:
Syntax: show ip pim nbr
This display shows the following information.
This Field... Displays...
Number of group prefixes The number f PIM Sparse group prefixes for which the RP is
responsible.
Group prefix Indicates the multicast groups for which the RP listed by the previous
field is a candidate RP.
RPs expected/received Indicates how many RPs were expected and received in the latest
Bootstrap message.
RP <num> Indicates the RP number. If there are multiple RPs in the PIM Sparse
domain, a line of information for each of them is listed, and they are
numbered in ascending numerical order.
priority The RP priority of the candidate RP. During the election process, the
candidate RP with the highest priority is elected as the RP.
age The age (in seconds) of this RP-set.
Note: If this Layer 3 Switch is not a BSR, this field contains zero. Only
the BSR ages the RP-set.
This Field... Displays...
Port The interface through which the Layer 3 Switch is connected to the
neighbor.
Neighbor The IP interface of the PIM neighbor interface.
FastIron SuperX Router(config-pim-router)# show ip pim nbr
Port Neighbor Holdtime Age UpTime
sec sec sec
e3/8 207.95.8.10 180 60 900
Port Neighbor Holdtime Age UpTime
sec sec sec
v1 207.95.6.2 180 60 900
To Next Page
Loading...
Need help?
General
