Configuring IP Multicast Protocols
December 2005 © Foundry Networks, Inc. 19 - 25
6 239.255.162.3 99.99.99.5
Syntax: show ip pim rp-map
This display shows the following information.
Displaying RP Information for a PIM Sparse Group
To display RP information for a PIM Sparse group, enter the following command at any CLI level:
Syntax: show ip pim rp-hash <group-addr>
The <group-addr> parameter is the address of a PIM Sparse IP multicast group.
This display shows the following information.
Displaying the RP Set List
To display the RP set list, enter the following command at any CLI level:
This Field... Displays...
Group address Indicates the PIM Sparse multicast group address using the listed RP.
RP address Indicates the IP address of the Rendezvous Point (RP) for the listed
PIM Sparse group.
This Field... Displays...
RP Indicates the IP address of the Rendezvous Point (RP) for the
specified PIM Sparse group.
Following the IP address is the port or virtual interface through which
this Layer 3 Switch learned the identity of the RP.
Info source Indicates the IP address on which the RP information was received.
Following the IP address is the method through which this Layer 3
Switch learned the identity of the RP.
FastIron SuperX Router(config-pim-router)# show ip pim rp-hash 239.255.162.1
RP: 207.95.7.1, v2
Info source: 207.95.7.1, via bootstrap
FastIron SuperX Router(config)#show ip pim rp-set
Group address Static-RP-address Override
---------------------------------------------------
Access-List 44 99.99.99.5 On
Number of group prefixes Learnt from BSR: 1
Group prefix = 239.255.162.0/24 # RPs expected: 1
# RPs received: 1
RP 1: 43.43.43.1 priority=0 age=0
To Next Page
Loading...
Need help?
General
