Touch Yes to confirm the change.
5. Touch Save.
Manually Setting the Printer's Ethernet
Interface Speed
The printer's Ethernet interface automatically detects the speed of your network. If your
network is connected to another auto-sensing device, such as a hub, the hub may not
detect the correct speed. Refer to the configuration page to make sure the printer has
detected the correct speed of your network. To view the configuration page, see Printing
the Configuration Report.
To manually set the speed of the printer's Ethernet interface:
1. Log in as a System Administrator.
2. At the printer Control Panel, press Machine Status, then touch the Tools tab.
3. Touch System Settings > Connectivity + Network Setup > Protocol Settings.
4. Touch Ethernet Settings and Change Settings.
5. Touch Ethernet Rated Speed and Change Settings.
6. Select the Speed to match the speed set on your hub or switch.
7. Touch Save, then Close.
Assigning a Network Address
By default, the printer automatically acquires a network address from a DHCP server.
To assign a static IP address, configure DNS server settings, or configure other TCP/IP
settings. Refer to TCP/IP.
Viewing Services and Options
To see which services and options are enabled or installed:
1. At the printer control panel, press the Machine Status button, then touch the
Machine Information tab.
2. Touch Machine Configuration.
2-3 Xerox
®
Color C60/C70 Printer
System Administrator Guide
Initial Setup
To Next Page
Loading...
Need help?
General
