Configuring TCP/IP Settings at the Control Panel
Manually Configuring an IPv4 Network Address
To configure an IPv4 network address:
1. At the printer Control Panel, press the Machine Status button, and then touch the
Tools tab.
2. Touch System Settings > Connectivity and Network Setup > Protocol Settings.
3. Select TCP-IP - Network Settings and Touch Change Settings.
4. Select IPv4 - IP Address Resolution, and touch Change Settings.
5. Touch Static, then touch Save.
6. Touch IPv4 - IP Address, and touch Change Settings.
7. Type the static IP address using the touch-screen keypad, and touch Save.
8. Touch IPv4 - Subnet Mask, and touch Change Settings.
9. Type the subnet mask using the touch-screen keypad, and touch Save.
10. Touch IPv4 - Gateway Mask, and touch Change Settings.
11. Type the gateway mask using the touch-screen keypad, and touch Save.
Manually Configuring an IPv6 Network Address
To configure an IPv6 network address:
1. At the printer Control Panel, press the Machine Status button, then touch the Tools
tab.
2. Touch Connectivity & Network Setup > Protocol Settings.
3. Touch IPv6 Address Manual Configuration, then touch Change Settings.
4. Touch Enabled, then touch Save.
5. Touch Manually Configured IPv6 Address, then touch Change Settings.
6. Type the static IP address using the touch-screen keypad, and touch Save.
7. Touch Manually Configured IPv6 Address Prefix, and touch Change Settings.
8. Type the prefix using the touch-screen keypad, and touch Save.
9. Touch Manually Configured IPv6 Address Gateway, and touch Change Settings.
10. Type the gateway using the touch-screen keypad, and touch Save.
Configuring IPv4 Dynamic Address Settings
To configure IPv4 dynamic address settings:
1. At the printer Control Panel, press the Machine Status button, then touch the Tools
tab.
2. Touch System Settings > Connectivity & Network Setup > Protocol Settings.
3. Touch IPv4 - IP Address Resolution, and touch Change Settings.
Xerox
®
Color C60/C70 Printer5-2
System Administrator Guide
Network Configuration