IPsec
Internet Protocol Security (IPsec) is a group of protocols used to secure Internet Protocol
(IP) communications by authenticating and encrypting each IP data packet. It allows
you to control IP communication by creating protocol groups, policies, and actions for
the following:
• DHCP v4/v6 (TCP and UDP)
• DNS (TCP and UDP)
• FTP (TCP)
• HTTP (Scan Out, TCP port 80)
• HTTPS (Scan Out, TCP port 443)
• HTTPS (Web Server, TCP port 443)
• ICMP v4/v6
• IPP (TCP port 631)
• LPR Print (TCP port 515)
• Port 9100 Print (TCP port 9100)
• SMTP (TCP/UDP port 25)
• SNMP (TCP/UDP port 161)
• SNMP Traps (TCP/UDP port 162)
• WS-Discovery (UDP port 3702)
• Up to 10 additional services
Configuring IPSec
Note
Secure HTTP (SSL) must be enabled with an installed digital certificate before you can
enable IPsec.
To configure Internet Protocol (IP) security communications:
1. In CentreWare Internet Services, click Properties > Security > IPSec.
2. Next to Protocol, select Enabled.
3. Select the IKE Authentication Method, Preshared Key, or Digital Signature.
4. If you select Preshared Key, type the Shared Key and retype the key to verify.
5. Type the IKE SA LIFE Time (5-28800 minutes).
6. Type the IPSec SA Life Time (300-172800 minutes).
7. Select the DH Group type.
8. Enable PFS if necessary.
9. Type the Specific Destination IPv4 Address.
Xerox
®
Color C60/C70 Printer6-16
System Administrator Guide
Security
To Next Page
Loading...
Need help?
General
