Fuji Xerox Color C70 System Administrator Guide

Raw TCP/IP Printing
Raw TCP/IP is a printing method used to open a TCP socket-level connection over Port
9100, to stream a print-ready file to the printer's input buffer. It then closes the
connection either after sensing an End-Of-Job character in the PDL or after expiration
of a preset time-out value. Port 9100 does not require an LPR request from the computer
or the use of an LPD running on the printer. Port 9100 is selected in Windows as the
Standard TCP/IP port.
Enabling Port 9100
Note
TCP/IP must be enabled before you enable Port 9100.
To enable port 9100:
1. In CentreWare Internet Services, click Connectivity > Port Settings.
2. Next to Port 9100, select Enabled.
Configuring Port 9100
To configure port 9100:
1. In CentreWare Internet Services, click Properties > Connectivity > Protocols >
Port 9100.
2. If necessary, next to TCP-MSS Mode, select Enabled.
3. If TCP-MSS mode is enabled, type the IP addresses for Subnets 1, 2, and 3 under
IPv4.
4. Ensure that the TCP Port Number is set to 9100.
5. Set the End of Job Timeout to the desired number of seconds between 0 and 1800
before processing a job with an End of Job character. The default time is 300 seconds.
6. Click Apply.
Note
TCP-MSS settings are common for LPD and Port 9100.
SMTP
Simple Mail Transfer Protocol (SMTP) is used by the printer's email feature to deliver
scanned images and Internet Fax jobs through email. After you enable SMTP, the email
button is enabled on the printer's Control Panel.
Xerox
®
Color C60/C70 Printer5-10
System Administrator Guide
Network Configuration

Fuji Xerox Color C70 Specifications

General

Brand	Fuji Xerox
Model	Color C70
Category	All in One Printer
Language	English