Note
Enabling or disabling IPv6 will restart the printer when you click Apply.
DNS Configuration for IPv6
To configure settings for IPv6:
1. Next to Obtain IPv6 DNS Server Address Automatically, select Enabled to allow
the DHCP server to provide the DNS server address.
2. Type an IP address for the Preferred DNS Server, Alternate DNS Server 1, and
Alternate DNS Server 2.
3. Next to Dynamic DNS Registration, select Enabled or select Overwrite to replace
the existing DNS entry.
4. Next to Generate Domain Search List Automatically, select Enabled to enable.
5. Type Domain Name 1, 2 and 3.
6. Enter the number of seconds until Connection Time-Out.
7. Click Apply.
SNMP
Simple Network Management Protocol (SNMP) is used in network management systems
to monitor network-attached devices for conditions that require administrative attention.
It consists of a set of standards for network management including an application layer,
a database schema, and a set of data objects. Agents, or software modules, reside in
the printer's SNMPv3 engine. A manager is an SNMPv3 management application such
as OpenView, that is used to monitor and configure devices on the network. The agent
responds to read (GET) and write (SET) requests from the manager and can also generate
alert messages, or traps, based on certain events.
SNMP settings can be configured in CentreWare Internet Services. You can also enable
or disable Authentication Failure Generic Traps on the printer. SNMPv3 can be enabled
to create an encrypted channel for secure printer management.
Enabling SNMP
To enable SNMP:
1. In CentreWare Internet Services, click Properties > Connectivity > Port Settings.
2. Next to SNMP, select Enabled.
3. Select UDP to enable this transport protocol if necessary.
Configuring SNMP
To configure SNMP settings:
Xerox
®
Color C60/C70 Printer5-6
System Administrator Guide
Network Configuration
To Next Page
Loading...
Need help?
General
