3 Paper and Other Media
110
Paper and Other Media
3
1 Pull out the tray towards you until it stops.
Important • While the machine is processing a job, do not pull the tray out that the job uses.
• To prevent paper jams or misloading, do not add paper on top of any remaining paper in the tray.
Remove any paper remaining in the tray, and then load that paper on top of the newly loaded
paper.
2 Remove any paper loaded in the tray.
3 With the side to be copied or printed on facing
up, load approximately 100 to 500 sheets and
align the edges of the paper in the arrow
direction (1). While pinching the long-side
paper guide, align the edge to the desired
paper size (2).
4 With the side to be copied or printed on facing
up, load the remaining paper and align the
edges of the paper in the arrow direction (1).
While pinching the left short-side paper guide,
align the edge to the desired paper size (2).
Important • Do not load paper exceeding the maximum
fill line. It may cause paper jams or machine
malfunctions.
• If the number of sheets is 100 or less, the
paper guides touch too tightly against the
paper, causing the paper to deform and
resulting in paper jams.
• Position the guides correctly to match the paper size. If the position of the guide is not correct, the
paper may not be fed properly and cause paper jams.
5 Push the tray in gently until it stops.
When pulling out the paper tray, do it
slowly. If pulled out with too much
force, the tray can hit and injure your
knees.
To Next Page
Loading...
