Handling Error Terminations
381
Job Status
11
Handling Error Terminations
This section describes how to handle error terminations.
For a Print Job
Select a job shown as an error termination on the [Completed Jobs] tab to check the error
code. Follow the instructions of the error code to solve the problem.
If an error occurs during a print job, the machine can be configured either to pause the print
job until the error is confirmed by the user, or to automatically cancel the error job so that
subsequent jobs can be printed.
For more information on the setting, refer to "Print Service Settings" (P.492).
For information on error codes, refer to "Error Code" (P.762).
For a Scan Job
A Transmission Report - Job Undelivered is printed.
For more information on the Transmission Report - Job Undelivered, refer to "Transmission Report - Job Undelivered"
(P.628).
For Other Jobs
Print a Job History Report, and check the execution results.
For information on the Job History Report, refer to "Job History Report" (P.436).
When an error code is listed in the Transmission Report - Job Undelivered or the Job History Report, refer to "Error Code"
(P.762).
To Next Page
Loading...
