Optional Components
931
Appendix
23
Optional Components
The following table shows the optional components available. To purchase these options,
contact our Customer Support Center.
Product Name Description
Offset Catch Tray Allows to eject paper with an offset.
Large Size UI Installation Kit A kit to set the Large Size UI Kit to the machine.
Large Size UI Installation Kit
2
A kit to set the Large Size UI Kit to the machine with HCF B1-S or
High Capacity Feeder C3-DS.
C3 Finisher Staples output.
C3 Finisher with Booklet
Maker
Staples output. It also folds output in half or staples folded
output.
Punch Unit 2/4H CD1 2/4 hole-punches output sheets.
Note • This kit is available only when the C3 Finisher or C3 Finisher
with Booklet Maker is installed.
Punch Unit US 2/3H CD1 2/3 hole-punches output sheets.
Note • This kit is available only when the C3 Finisher or C3 Finisher
with Booklet Maker is installed.
Finisher D4 Staples or hole-punches output.
Inserter is installed for loading paper to be used as separators and
covers.
Note • The Finisher D5 is required to connect a 3rd vendor finisher.
Finisher D5
Finisher D4 with Booklet Staples or hole-punches output. It also folds output in half or
staples folded output.
Inserter is installed for loading paper to be used as separators and
covers to bind booklets.
Finishing Transport Module Connects a 3rd vendor finisher to the Finisher D5.
D4/D5 Folder Unit Used to fold sheets in Z-folded or C-folded form.
Note • This is available only when the Finisher D4, the Finisher D4
with Booklet, or Finisher D5 is installed.
2/3 Hole Punch Kit for
Finisher D4
The number of punching holes can be changed to 3.
Note • 2 and 4 punching cannot be used when this option is
installed.
• This is available only when the Finisher D4, the Finisher D4
with Booklet, or the Finisher D5 is installed.
Squarefold Trimmer Module Presses the spine of a booklet to form the square-shaped spine like
a book. It also trims the fore edge, which is opposite of the spine,
to finish the edge neatly.
Note • This option is available only when the Finisher D4 with
Booklet is installed.
High Capacity Stacker Allows you to output up to 5,000 sheets of paper (when using FX P
Paper).
Stacker Cart A cart for carrying paper output from the High Capacity Stacker.
Interface Module Used when installing the Finisher D4, Finisher D4 with Booklet,
Finisher D5, or High Capacity Stacker to the machine.
Note • For GBC
®
AdvancedPunch
TM
, refer to the manual supplied
with the device.
To Next Page
Loading...
