Fuji Xerox Versant 80 Press

Connectivity & Network Setup
471
Tools
13
Important • To display the online help for CentreWare Internet Services, users need to have the environment to
connect to the Internet. The communication fee shall be borne by you.
UPnP Discovery
 Port Status
Select [Enabled] to use UPnP.
 Port Number
Enter a port number for UPnP communication from 1 to 65535.
The default value is 80.
Important • Do not use a number that is the same as a port number of another port. However, you can use the
same port number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP,
WebDAV, and Web Services on Devices (WSD)).
WSD
Note •WSD stands for Web Services on Devices.
 WSD Print - Port Status
Select [Enabled] to use WSD Print.
Set this when you search a device on a network from Windows Vista
®
, Windows
®
7,
Windows
®
8, Windows
®
8.1, Windows Server
®
2012, and Windows Server
®
2012 R2.
 WSD Scan - Port Status
Select [Enabled] to use WSD Scan.
Set this when you search a device on a network from Windows Vista®, Windows
®
7,
Windows
®
8, Windows
®
8.1, Windows Server
®
2012, and Windows Server
®
2012 R2.
 Port Number
Enter a port number from 1 to 65535.
The default value is 80.
Important • Do not use a number that is the same as a port number of another port. However, you can use the
same port number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP,
WebDAV, and Web Services on Devices (WSD)).
Internet Services (HTTP)
 Port Status
Select [Enabled] to use CentreWare Internet Services.
For more information about CentreWare Internet Services, refer to "CentreWare Internet Services Settings" (P.555).
 Port Number
Enter a port number for the Internet Services from 1 to 65535.
The default value is 80.
Important • Do not use a number that is the same as a port number of another port. However, you can use the
same port number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP,
WebDAV, and Web Services on Devices (WSD)).
Note •You cannot select [Port Number], if HTTP port is disabled.
To configure [Port Number], enable port status and reboot the machine, and then configure [Port
Number].