21 Maintenance
676
Maintenance
21
2 Pull out the hole punch waste container [R4] towards you.
3 Discard all the scraps.
4 Insert the empty hole punch waste container all the way into the machine.
5 Close the door of the finisher.
Note • A message will be displayed and the machine will not operate if the door of the finisher is not closed
properly.
Emptying the Trimmer Waste Container
When the optional Squarefold Trimmer Module is installed and the optional trimmer waste
container becomes full, a message appears on the touch screen. Discard the scraps
according to the message.
If you take the trimmer waste container out of the machine, make sure to empty it
completely. If it is reinstalled with some scraps remaining, it may become full before the
message appears again, and this can cause machine breakdown.
Important • When emptying the trimmer waste container, make sure that the machine is switched on. If not
switched on, the machine will not recognize that the trimmer waste container has been emptied.
Finisher D4/
Finisher D4 with Booklet/
Finisher D5
Finisher C3/
Finisher C3 with Booklet Maker
Finisher D4/
Finisher D4 with Booklet/
Finisher D5
Finisher C3/
Finisher C3 with Booklet Maker
To Next Page
Loading...
