4 Copy
198
Copy
4
Transparency Set & Handouts
Makes copies on transparencies. At the same time, the required number of copies is made
for handouts.
Transparency Tray
Allows you to select the paper tray to be used for the transparencies.
Select [More] to display the [Paper Supply - Transparency] screen on which you can select a
tray.
Note •For [Transparency Tray], select one of the paper trays. Auto Paper Select feature is not available.
• The paper tray that you selected for [Transparency Tray] cannot be selected for [Separator Tray],
[Separator & Handout], or [Handout Tray] at the same time.
Separator Tray
Allows you to select the paper tray to be used for the separators.
Select [More] to display the [Paper Supply - Separator] screen on which you can select a tray.
Note •For [Separator Tray], select one of the paper trays. Auto Paper Select feature is not available.
• The paper tray that you selected for [Transparency Tray] cannot be selected for [Separator Tray] at
the same time.
Separator & Handout
Allows you to select the paper tray to be used for the separators and handouts.
Select [More] to display the [Paper Supply - Separator & Handout] screen on which you can
select a tray.
Note •For [Separator & Handout], select one of the paper trays. Auto Paper Select feature is not available.
• The paper tray that you selected for [Transparency Tray] cannot be selected for [Separator &
Handout] at the same time.
Handout Tray
Allows you to select the paper tray to be used for the handouts.
Select [More] to display the [Paper Supply - Handout] screen on which you can select a tray.
Note •For [Handout Tray], select one of the paper trays. Auto Paper Select feature is not available.
• The paper tray that you selected for [Transparency Tray] cannot be selected for [Handout Tray] at
the same time.
Copy Output (Specifying Finishing Options)
This feature allows you to select finishing options.
Note •An optional component is required. For more information, contact our Customer Support Center.
• Displayed items differ depending on the attached options.
If the Offset Catch Tray (optional) is installed, the output position of copies can be offset
alternately to separate each set of copies.
If any Finisher (optional) is installed, each set of copies can be stapled and then output.
If a punch unit is installed, the output can be punched.
To Next Page
Loading...
