Fuji Xerox Versant 80 Press

13 Tools
438
Tools
13
Delete All Data
This feature is designed to prevent the leakage of confidential information of a customer
when the machine is returned to Fuji Xerox. All data stored on the machine will be deleted.
Before executing this operation, make sure that the operation is absolutely necessary.
Note •It takes several minutes to several hours to delete all data. (The time taken depends on the machine
configuration or the hard disk capacity.)
Software Options
This feature is for service representative use. For more information, contact our Customer
Support Center.
Power on Self Test
Set whether or not to perform self test when the machine is turned on and started up. If any
abnormal condition such as intentional program modification is found during the program
diagnosis, the machine stops starting up and records the information in the audit log.
Note •The information may not be recorded in the audit log depending on the status of program
malfunction.
• If the machine does not start, contact our Customer Support Center.
Check Smart Card Details
When you select [Check Smart Card Details] and touch your smart card to the smart card
reader, the information of the smart card appears on the touch screen.
Note •You can register the authentication information using CentreWare Internet Services. For more
information, refer to the help of CentreWare Internet Services.
Important • To display the online help for CentreWare Internet Services, users need to have the environment to
connect to the Internet. The communication fee shall be borne by you.
Alignment Adjustment
You can adjust output image (perpendicular angle (rhombic distortion), ratio, and print
position).
 Auto Alignment Adjustment
The machine analyzes the image and sets the adjustment value by scanning the sample
output.
For more information, refer to "Auto Alignment Adjustment Settings" (P.688).
 Manual Alignment Adjustment
You can set the adjustment value manually.
80 types of adjustment values can be set for each paper type. The specified types are
assigned to each paper tray. Use this feature to match the positions of the images on front
and back surfaces when you print with register mark or when you cut the output.
For more information, refer to "Manual Alignment Adjustment" (P.695).
Density Uniformity Adjustment
You can adjust output image (density).
 Semi Auto Process Using Scanner
The machine analyzes the image and sets the adjustment value by scanning the sample
output.
For more information, refer to "Density Uniformity Adjustment (Manual Process)" (P.706).