21 Maintenance
710
Maintenance
21
-For Z fold, refer to "Z Fold Position Adjustment" (P.714).
-For Z fold half sheet, refer to "Z Fold Half Sheet Position Adjustment" (P.715).
Single Fold Position Adjustment
Adjust the single fold position.
1 Select [Single Fold], and then select [Change
Settings].
2 Specify [Sheets to be folded], and then select
[Sample Printout].
3 Select the tray in which you loaded paper, and
press the <Start> button.
A sample printout is printed.
4 Select [Close].
5 Check the sample printout, measuring the misaligned amount.
6 Select [Long at Left] or [Long at Right], and
enter the value you measured in step 5 in
[Value A Before Adjustment].
7 Select [Adjust].
8 Select [Sample Printout] again.
9 Select the tray in which you loaded paper, and press the <Start> button.
The sample printout is printed.
10 Select [Close].
11 Confirm the result of sample printout.
12 Adjust the alignment again if necessary.
To Next Page
Loading...
