Connectivity & Network Setup
473
Tools
13
Protocol Settings
Set the parameters required for communications. [Protocol Settings] consists of the
following categories:
z
Ethernet Settings
z
TCP/IP - Common Settings
z
TCP/IP - Network Settings
Note •To configure each category, select the corresponding item and then select [Change Settings].
Also on [Ping Connection Test], you can check whether or not the machine can be properly
connected to a network with the configured condition.
Ethernet Settings
Configure the Ethernet settings.
Ethernet1 - Network Name, Ethernet 2 - Network Name
When two Ethernet interfaces are used, specify the names respectively.
Note •This item is displayed only when Secondary Ethernet (optional) is installed on the machine.
Ethernet - Rated Speed / Ethernet 1 - Rated Speed, Ethernet 2 - Rated Speed
Select the communication speed from the followings:
Note •The title of this setting item differs depending on the Ethernet interface configuration: When single
Ethernet interface is used, [Ethernet - Rated Speed] is displayed. When two Ethernet interfaces are
used, [Ethernet 1 - Rated Speed] and [Ethernet 2 - Rated Speed] are displayed.
z
Auto
Select this to detect the Ethernet transmission rate automatically.
z
100 Mbps Full-Duplex
Select this to set 100BASE-TX (Full Duplex) as the default value.
z
100 Mbps Half-Duplex
Select this to set 100BASE-TX (Half Duplex) as the default value.
z
10 Mbps Full-Duplex
Select this to set 10BASE-T (Full Duplex) as the default value.
z
10 Mbps Half-Duplex
Select this to set 10BASE-T (Half Duplex) as the default value.
z
1000 Mbps
Select this to set 1000BASE-T as the default value.
Note •Gigabit Ethernet Kit (optional) is required for using 1000BASE-T.
TCP/IP - Common Settings
Configure common settings to use TCP/IP.
Primary Network
When two Ethernet interfaces are used, the interface name specified in [Ethernet1 -
Network Name] is displayed.
Note •The primary network is "Ethernet 1". You cannot set "Ethernet 2" as the primary network.
• This item is displayed only when Secondary Ethernet (Optional) is installed on the machine.
You cannot edit the setting from here.
To Next Page
Loading...
