Fuji Xerox Versant 80 Press

13 Tools
472
Tools
13
SOAP
 Port Status
Select [Enabled] when you use an application program such as Device Setup Tool.
 Port Number
Enter a port number for SOAP from 1 to 65535.
The default value is 80.
Important • Do not use a number that is the same as a port number of another port. However, you can use the
same port number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP,
WebDAV, and Web Services on Devices (WSD)).
WebDAV
 Port Status
Select [Enabled] when you use an application program such as Network Scanner Utility 3 to
access folders in the machine.
Important • We recommend you to enable [HTTP - SSL / TLS Communication] under [SSL / TLS Settings] when
you use WebDAV. This is an effectual way to avoid password leaking.
Note •You cannot select [Port Number] and [Operation Time-Out], if WebDAV port is disabled.
To configure [Port Number] and [Operation Time-Out], enable port status and reboot the machine,
and then configure [Port Number] and [Operation Time-Out].
 Port Number
Enter a port number for WebDAV from 1 to 65535.
The default value is 80.
Important • Do not use a number that is the same as a port number of another port. However, you can use the
same port number for a port that uses HTTP (PP, Internet Services (HTTP), UPnP Discovery, SOAP,
WebDAV, and Web Services on Devices (WSD)).
 Operation Time-Out
You can enter an operation time-out period between 1 and 65535 seconds in 1 second
increments.
ThinPrint
 Port Status
You can use the machine for print in the ThinPrint
®
print environment. The machine
decompresses and prints the compressed print data sent from the print server.
Select [Enabled] when you use ThinPrint.
 Port Number
Enter a port number for ThinPrint from 1 to 65535.
The default value is 4000.
Important • Do not use any numbers assigned to the other ports.
Note •ThinPrint is available when the communication protocol uses IPv4.
• The maximum of three connections are possible at a time.