Fuji Xerox Versant 80 Press

Power Saver Mode
71
Product Overview
2
Exiting the Power Saver Mode
1
Press the <Power Saver> button.
Also, the Power Saver mode is exited in the following instances.
z
Receiving a job
z
Selecting [Apply] in CentreWare Internet Services
Changing the Interval for Entering Power Saver Mode
You can set the time to elapse until the machine enters the Low Power mode and the Sleep
mode from 1 to 240 minutes in 1 minute increments.
Note •If the preset time period is the same for the Low Power mode and the Sleep mode, the machine
directly enters the Sleep mode without entering the Low Power mode first.
• When the machine operates normal printing or Sample Set printing while the control panel remains
lit off and the machine is in the Power Saver mode, only the output device exits the Power Saver
mode. In this case, the machine enters the Sleep mode 15 seconds later without following this
setting by factory default.
1 Press the <Log In/Out> button.
2 Enter the system administrator’s user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s passcode,
and select [Enter].
Note •The default user ID is "11111".
• The default passcode is "x-admin".
3 Select [Tools] on the Services Home screen.
Note •When the Services Home screen is not
displayed on the touch screen, press the
<Services Home> button.
123
456
789
0
＃
<Log In/Out> button
123
456
789
0
＃
<Log In/Out> button