21 Maintenance
680
Maintenance
21
4 Wipe the document presser (3).
Note • If dirt does not come off easily, gently wipe it
with a soft cloth moistened with a small
amount of neutral detergent.
Important • Do not use cleaning agents other than water
or neutral detergent.
5 Hold the green handle to open the chute part,
and wipe the constant velocity transport glass
(4).
Important • Do not use cleaning agents other than water
or neutral detergent.
• Do not push the constant velocity transport
glass strongly since it is easy to damage the
film around the optical glass surface.
Note • If dirt does not come off easily, gently wipe it
with a soft cloth moistened with a small
amount of neutral detergent.
6 Close the chute part.
7 Lower the document feeder.
8 Press the power switch [ ] to switch on the power.
9 Lift and lower the document feeder again.
Cleaning the Document Feeder Rollers
If the document feeder roller is dirty, streaks or smears may appear on copies and document
jams may occur.
To ensure clean copies at all times, clean the document feeder roller about once a month.
Important • Do not use benzene, paint thinner, or other organic solvents. Doing so might damage paint or
coating on plastic parts.
• Cleaning the machine with an excessive amount of water may cause the machine to malfunction or
damage documents during copying or scanning.
1 Pull up the handle of the document feeder top
cover, and open the top cover until it stops.
Note • When you fully open the cover, it enters a
fixed position. Open the cover gently.
Chute
constant velocity
transport glass (4)
To Next Page
Loading...
