Fuji Xerox Versant 80 Press

Calling a Stored Program
337
Stored Programming
8
Calling a Stored Program
The following describes how to call a stored program.
When you call a specified stored program, the last screen shown when you registered the
stored program appears.
1 Press the <Services Home> button.
Select [Stored Programming].
2 Select a number of a stored program
containing the features you want to use.
Note •You can only select registered numbers.
• Scroll the list by drag or flick operation to switch the screen to be displayed. For information on how
to drag or flick, refer to "Touch Screen" (P.88).
• Select [ ] to return to the previous screen or [ ] to move to the next screen.
• After the stored program has been called, the machine sounds an audible tone. If a failure occurs,
the machine sounds a fault tone.
For information on how to change the volume of the sound that notifies that a stored program has been called, refer to
"Stored Programming Complete Tone" (P.425).
3 After the stored program is called, select other features if necessary.
4 Press the <Start> button.
123
456
789
0
＃
<Services Home> button
Start
123
456
789
0
＃
C
<Start> button