13 Tools
470
Tools
13
Bonjour
Port Status
Select [Enabled] to use Bonjour
®
.
Note •To print from a printer detected by [Bonjour], the LPD port must be activated in advance.
Port 9100
Port Status
Select [Enabled] to use Port9100
®
.
Select this option when the communication protocol is in the RAW format for the Windows
Standard TCP/IP port monitor.
Port Number
Enter a port number for Port9100 from 1 to 65535.
The default value is 9100.
Important • Do not use the numbers assigned to the other ports.
SNMP
Port Status
Select [Enabled] to use SNMP, when you use any web applications manufactured by Fuji
Xerox to control the machine on the network.
FTP Client
Port Status
Select [Enabled] when you use the Scan to PC service with FTP transmission.
Note •Select a communication mode to send data scanned via FTP from [Passive Mode] and [Active
Mode]. [Active Mode] is selected by factory default. You can change the setting from CentreWare
Internet Services.
Receive E-mail
Port Status
Select [Enabled] when you receive e-mails.
Send E-mail
Port Status
Select [Enabled] when you send e-mails.
E-mail Notification Service
Port Status
Select [Enabled] when you use the E-mail Notification Service. The E-mail Notification
Service notifies you of the machine status or the completion of a print job by e-mail.
Note •[Consumables Status], [Parts Status], [Paper Tray Status], [Output Tray Status], [Jam Status],
[Interlock Status], and [Fault Notice] are notified as the machine status.
• You can configure the E-mail Notification Service in CentreWare Internet Services. For more
information, refer to the help of CentreWare Internet Services.
To Next Page
Loading...
