Fuji Xerox Versant 80 Press

13 Tools
482
Tools
13
The settings in [Kerberos Server 1 (Default)] will be the default settings for authentication.
 Primary Server Name/Address
Enter the primary server name or IP address.
Note •For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
 Primary Server - Port Number
Set the primary server port number from 1 to 65535.
The default value is 88.
Important • Do not use the numbers assigned to the other ports.
 Secondary Server Name/Address
Enter the secondary server name or IP address.
Note •For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
 Secondary Server - Port Number
Set the secondary server port number in the range from 1 to 65535.
The default value is 88.
Important • Do not use the numbers assigned to the other ports.
 Domain Name
When you use Active Directory of Windows 2000 Server, Windows Server
®
2003, Windows
Server 2008 or Windows Server 2012 as server, specify the domain name of Active Directory
in [Domain Name]. Up to 64 characters are allowed.
Important • Enter a realm name in uppercase characters. Otherwise, an authentication error occurs.
 Server Certificate Verification
Select whether or not to verify a server certificate.
LDAP Server/Directory Service Settings
Configure the directory server, authentication method, and search attributes and ranges for
LDAP authentication and the Address Book search by LDAP.
 Primary Server Name/Address
Enter the primary server name or IP address.
Note •For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to
255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
 Primary Server - Port Number
Set the Primary server port number from 1 to 65535.
The default value is 389.
Important • Do not use the numbers assigned to the other ports.