Print Service Settings
497
Tools
13
Important • This setting is valid only when [Receiving Buffer - LPD] is set to [Spool to Hard Disk]. When any other
setting, printing is performed in [Data Processing Order].
OCR Font Glyphs (0 x 5C)
Allows you to select [Backslash] or [Japanese Yen Sign] to print 0x5C character when the
OCR fonts are used.
Note •An optional component is required to use this feature. For more information, contact our Customer
Support Center.
Paper Settings for Print Job
The machine and the print driver support different types of paper. So the machine converts
the paper type and weight, and executes the print job. You can set the paper weight for each
supported paper type.
The following table shows the correspondence between the print driver setting and the
supported paper types.
Print Driver Setting
Supported Paper Type /
Paper Weight Default
Available Paper Weight
Plain Uncoated / 81-90 gsm 52- 63 gsm
64-80 gsm
81-90 gsm
91-105 gsm
106-135 gsm
136-157 gsm
158-176 gsm
177-220 gsm
221-256 gsm
257-300 gsm
301-350 gsm
Heavyweight (HW) Uncoated / 106-135 gsm
HW Reload Uncoated Reload / 106-135 gsm
Extra-HW (X-HW) Uncoated / 177-220 gsm
X-HW Reload Uncoated Reload / 177-220 gsm
Custom Paper 1 to 5 Uncoated / 81-90 gsm
Plain Reload Uncoated Reload / 81-90 gsm
Not Set / other than
above
Uncoated / 81-90 gsm
To Next Page
Loading...
