Executing Calibration
683
Maintenance
21
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the Services Home screen.
Note • When the Services Home screen is not
displayed on the touch screen, press the
<Services Home> button.
4) Select [System Settings] > [Common Service
Settings] > [Image Quality Adjustment].
5) Select [Calibration].
2 Set [Screen Type], [Paper Supply], and [Target].
Note • The following describes calibration
procedures using Copy Job 2, as an example.
• For [Paper Supply], select the paper tray in
which A4 , A3 , 8.5 x 11" , or 11 x 17"
white paper is loaded.
• For Target, select from [Copy & Print Jobs],
[Copy Jobs Only], [Print Jobs Only], and
[None]. When [Copy & Print] is not selected
for [Target], calibration is not valid for the
mode not listed in [Target].
3 Select [Start].
123
456
789
0
＃
To Next Page
Loading...
