Adjust Paper Curl
719
Maintenance
21
8 Specify a adjustment value each for [1 Sided -
Face Up], [1 Sided - Face Down], and [2 Sided].
For available option on the setting screen refer to "Paper Curl
Adjustment Types" (P.717).
9 Select [Sample Printout].
10 Select the paper tray you loaded paper, and
then select [Paper Feed Method], [Number of
Sheets], [Front Print Density], and [Back Print
Density].
Note • We recommend that you print about 10
sheets to calculate the average value of the
variations.
11 Press the <Start> button.
The sample print is printed.
12 Select [Confirm].
13 Select [Close].
14 Confirm the sample printout. Correct the curl
adjustment value as required.
Note • For available option on the setting screen,
refer to "Paper Curl Adjustment Types"
(P.717).
15 Select [Sample Printout] again.
16 Select the paper tray you loaded paper, and then set [Paper Feed Method], [Number of
Sheets], [Front Print Density], and [Back Print Density].
17 Press the <Start> button.
The sample printout is printed.
18 Make adjustment again if necessary.
Note • For available option on the setting screen
refer to "Paper Curl Adjustment Types"
(P.717).
19 Select [Save].
20 Select [Close] until the Services Home screen is displayed.
Note • When you configure settings under [System Settings] or [Setup] and then press the <Services Home>
button, the screen directly goes back to the Services Home screen.
To Next Page
Loading...
